Anti-Walk Pins Installation

STOP!!

You MUST ensure your firearm is fully unloaded and PROVED safe before using!!

PROVE
Point the firearm in the safest available direction.
Remove all ammunition.
Observe the chamber.
Verify the feeding path.
Examine the bore.

Once safe, you may proceed to the next step.

STEP 1: REMOVE ONE OF SCREWS FROM THE ANTI-WALK PIN.
STEP 2: INSERT ANTI-WALK PIN THROUGH LOWER RECEIVER PASSING THROUGH THE TRIGGER GROUP.
STEP 3: SCREW IN REMAINING SIDE SCREW FROM STEP 1.
USING (2X) ALLEN KEYS, TIGHTEN BOTH SIDES SIMULTANEOUSLY.

NOTE: FOR SEMI-PERMANENT INSTALLATIONS, A SMALL AMOUNT OF BLUE OR PURPLE LOCTITE CAN BE USED. NEVER USE RED LOCTITE!