Competition Magwell Flare Installation

STOP!!

YOU MUST ENSURE YOUR FIREARM IS FULLY UNLOADED AND PROVED SAFE BEFORE USING!!

PROVE
POINT THE FIREARM IN THE SAFEST AVAILABLE DIRECTION.
REMOVE ALL AMMUNITION.
OBSERVE THE CHAMBER.
VERIFY THE FEEDING PATH.
EXAMINE THE BORE.

ONCE SAFE, YOU MAY PROCEED TO THE NEXT STEP.

TOOLS REQUIRED:
STANDARD BUTTON RETAINING PIN REQUIRES 1/16 0.062 INCH HEX ALLEN KEY
BLUE LOCTITE (OPTIONAL)

Instructions work for all Brass Deflectors and Side Charging Covers
LTAC Raven Competition Magwell Flare [9mm]
LTAC Raven Competition Magwell Flare [5.56 NATO]

NOTE: DIFFERENT COLORS OF CERAKOTE HAVE A DIFFERENT THICKNESS. THESE FLARES ARE MADE TO HAVE A VERY TIGHT FITTING TOLERANCE TO ENSURE PERECT PERFORMANCE. WHILE INSTALLING A TINY AMOUNT OF CERAKOTE MAY BECOME SCUFFED OR SCRATCHED. IT WILL BE COMPLETELY HIDDEN WHILE THE FLARE IS INSTALLED.

NOTE: WHILE NOT NEEDED IN MOST CASES, YOU MAY ADD A SMALL AMOUNT OF BLUE LOCTITE TO THE SCREW THREADS BEFORE INSTALLING FOR MORE PERMANENT INSTALLS.

DO NOT USE RED LOCTITE!

STEP 1: INSTALL SUPPLIED SCREWS INTO MAGWELL FLARE. DO NOT TIGHTEN!

STEP 2: SLIDE COMPETITION MAGWELL FLARE INTO POSITION STARTING AT THE FRONT OF THE MAGWELL AND SLIDING IT INTO PLACE.

STEP 3: ONCE FULLY SEATED, TIGHT THE TWO SET SCREWS AT THE BOTTOM. DO NOT OVER TIGHTEN AS YOU CAN DAMAGE THE THREADS.

AFTER THE FIRST 50-100 ROUNDS ARE FIRED, WE RECOMMEND RECHECKING TIGHTNESS ON ALL SCREWS.